This site uses cookies. By continuing to browse the ConceptDraw site you are agreeing to our Use of Site Cookies.
A simple hydraulic schematic showing apparatus for testing the strength of a hydraulic hose splice.
Water enters through normally closed solenoid valve (1) and passes through intake flow meter (2) to high pressure pump (4). Intake water pressure is monitored by pressure gauge (3). The hose to be tested connects between pump (4) and normally open solenoid activated drain valve (7). To test the hose, pump drive motor (5) is turned on, the solenoid of drain valve (7) is activated, closing the valve, and the pump is run to pressurize the hose. Test pressure is monitored by gauge (6). When the test is complete or the hose fails, the solenoid of drain valve (7) is deactivated, opening valve and discharging water, depressurizing the system. All components are operated electrically by a remote control circuit so that the operator may perform the test from a protected location, monitoring it with a camera and video monitor.
This hydraulic schematic example was redrawn using ConceptDraw PRO diagramming and vector drawing software from the Wikimedia Commons file: Hydraulic schematic.jpg.
[commons.wikimedia.org/ wiki/ File:Hydraulic_ schematic.jpg]
This file is licensed under the Creative Commons Attribution-Share Alike 3.0 Unported license.
[creativecommons.org/ licenses/ by-sa/ 3.0/ deed.en]
This hydraulic engineering drawing example is included in the Mechanical Engineering solution from Engineering area of ConceptDraw Solution Park.
www.conceptdraw.com/ solution-park/ engineering-mechanical
Page1
Page1,  variable spring, valve, two-position, two-port, spring, solenoid, pressure gauge, pressure, non-variable spring, mechanical drawing, hydraulic pump vector stencils, hydraulic pump, hydraulic motor symbols, geometric dimensioning and tolerancing, GD&T, gauge, flow meter, engineering tolerances, engineering drawing, energy source, electric motor, electric linear, dimensions, callout